zinc round tube weight calculator

Enter the dimensions of a zinc round tube and this works out its volume and weight. Pure zinc. ZAMAK die-casting alloys run 6600-6800.

Outside diameter

Wall thickness

Length

Number of pieces

Total weight

3.162 77kg

≈ Rounded zinc round tube weight Show in

Weight of one round tube: 3.162 77
Volume of one piece: 442.965
Weight per metre of length: 3.162 77 kg/m
Density used: 7140 kg/m3

Show the working

Outside diameter = 50
Wall thickness = 3
Length = 1000
Number of pieces = 1
volume_mm3 = pi/4 * (50^2 - (50 - 2*3)^2) * 1000 = 442 965
Volume of one piece = 442 965 / 1000 = 442.965
Density used = 7140 = 7140
Weight of one round tube = 442 965 * 7140 / 1e9 = 3.162 77
Total weight = 3.162 77 * 1 = 3.162 77
Weight per metre of length = 442 965 / 1000 * 1000 * 7140 / 1e9 = 3.162 77

Values are shown to six significant figures here; the arithmetic itself runs on exact fractions and is only rounded where a number is printed.

Scenarios & local history

Compare a saved scenario

Recent calculations

The formula

Volume = (pi / 4) x (OD^2 - ID^2) x length, where ID = OD - 2 x wall
Weight = volume x density, with density = 7140 kg/m3
One cubic millimetre of a material at 1000 kg/m3 weighs exactly one milligram, so the millimetre-to-kilogram step is a shift of the decimal point rather than a rounded factor.

Pure zinc. ZAMAK die-casting alloys run 6600-6800.

Dimensions are nominal. Mill tolerances on thickness, and the corner radii on formed sections, both move the real weight by a percent or two.

Every field takes inches or feet as readily as millimetres: change the unit next to it and the conversion is done exactly before the arithmetic starts.

Frequently asked

What is the density of zinc?

7140 kg/m3, which is 7.140 g/cm3. Pure zinc. ZAMAK die-casting alloys run 6600-6800.

How do you calculate the weight of a zinc round tube?

Volume = (pi / 4) x (OD^2 - ID^2) x length, where ID = OD - 2 x wall. Multiply the volume by the density of zinc, 7140 kg/m3, taking care that both are in the same unit system.

Can I enter dimensions in inches?

Yes. Each dimension field has its own unit selector, and inch, foot, millimetre, centimetre and metre entries are all converted exactly before anything is multiplied.

Where the numbers come from

Densities are nominal room-temperature values for the grade named, drawn from the usual mill and handbook figures.